Hard Anodized Black MDC Bodyguard Flashlight. This flashlight is a specialized tactical use flashlight with up to 600 out the front lumens depending on battery configuration.
The 1 CR123 Body has a Black Type III Hard Anodized finish, protruding tailcap button, and McClicky forward clicky (latching) switch. The head is fully potted and utilizes a TIR Optic for a good balance of spot and spill. The LED is a Cool White (6200K) Cree XP-L.
The single cell MDC Bodyguard Flashlight will support one primary CR123 lithium battery or one rechargeable Li-ion battery. IMR type High drain type battery is recommended. You can purchase batteries and chargers directly from us in the Batteries and Chargers section of the Web Store.
Mode of Operation:
When activated the light comes on in High. The light will maintain this output for 10 seconds. The light will automatically step down to a lower output after the initial 10 seconds. Each time the switch is activated, the countdown timer is reset. In this fashion, the light Always comes on in the Highest output. The lower output is to maintain tactical awareness without overheating the light or the battery.
Summary of Output:
CR123 (3 volts) ------ 450 lumens Momentary, 375 lumens 10 sec., 150 lumens
IMR 16340 ------ 600 lumens Momentary, 550 lumens 10 sec., 150 lumens
Battery life is dependent on the amount of high output time utilized. The light will pull 2+ Amps at high output. Expect 15 to 60 minutes of usage depending on how the high output mode is used. A Rechargeable IMR 16340 battery will give the best balance of performance/runtime.
This Flashlight is protected from reverse polarity.
Length: 3.75 inches
Diameter: 1 inch (head)
This Flashlight was designed for rugged service from the ground up. It is fully potted to stand up to rough service and recoil. This Item is Covered by Our Lifetime Warranty.
Things to Know Before Purchase:
This flashlight was designed for use with a single primary lithium CR123 Battery, or one rechargeable Li-ion cell. Best balance of performance/runtime is achieved with IMR chemistry.
The input voltage of the Head is 3 - 6 volts. Input voltages of more than 6 volts may damage this flashlight.
This light is protected against reverse polarity.
WARNING: This light is capable of causing eye damage at close range. Please use the light responsibly!!!
Made in the USA. Some parts not domestically sourced.